header1

NOTE! This site uses cookies and similar technologies.

If you not change browser settings, you agree to it.

I understand

Initially, our target was to identify and eliminate the critical points of the whole process leading to the implementation of your mould.

After receiving the order and evaluating any possible solutions, we make a proof of assembly, where all the factors are taken into examination.

Then, following the project optimization and approval, we define the general lines of the job to be executed and then, on the basis of the final drawings, a working cycle is defined for each component including the sequences, the processing methods and the destination to the most suitable processing unit. The analysis is focused on execution variables for the most complex details.

Upon completion of the production and assembly processes, each mould is strictly tested at our factory, and then, if necessary,  all necessary changes are made in order to optimize the equipment.

phoca thumb m pianificazione01 phoca thumb m pianificazione02 phoca thumb m pianificazione03